Diezel Herbert Manual do Utilizador descarregar pdf (Página 11)

3.2.7 Compensated Out

A frequency corrected signal will leave this jack if you connect it to a mixer or recording

device. Use it to quietly compose or send an auxiliary signal to a console etc. Always make

sure that your amp is connected to either a loudspeaker or a load (i.e. THD HotPlate).

3.2.8 Speaker Connections

Herbert has 5 speaker jacks: 1 for a 16-Ohm load, 2 for 2 16-Ohm loads or 1 8Ohm load,

and 2 for 2 8-Ohm loads or 1 4-Ohm load. Confusing? Oh, yes! Just do what it says on

the jacks, and you’ll be fine

3.2.9 Top 5 Reasons for dynamic losses in the effects loop

Many different factors can be responsible for loss of dynamics, aside from those mentioned

in 3.2.2 (ADA conversion). A vital point that often leads to frustration is a maladjusted

output level of an effects unit. If the output level is too high, then unwanted distortion is

caused in the power amp. If it is too low, then the rig will not sound punchy and might get

lost easily in the band sound. When used in the serial loop, the output of the effects unit

determines the ultimate drive signal strength of the power amp. The output level should be

matched to give the best possible sound with all 3 channels without over driving the power

amp section. Headroom adjustments of 10% are usually sufficient.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sem comentários

Diezel Herbert Manual do Utilizador Página 11